The quality of the products
Excerpt from the technical guidelines "Solid, finger-jointed and laminated profiles for wooden windows":

Fotos 02Fotos 02Fotos 02Fotos 02
  • Wood moisture content of 13+/-2% must be maintained during the entire production process.
  • The annual ring inclination must correspond to rift or semi-rift.
  • The annual ring width within a cross-section must not exceed 6 mm.
  • The difference between the annual ring widths of connected parts must not exceed 3 mm.
  • The apparent density r12 must be at least 350 kg/m³ for softwoods and at least 550 kg/m³ for hardwoods.
  • Thickness tolerances of max. +/-0.1 mm for the lamellas to be bonded must not be exceeded.
  • In addition to the required stress group D4 according to ÖNORM EN 204, the adhesives must have a temperature resistance at 80 °C.
  • For softwoods the pressing pressure should not be less than 0.5 N/mm², for hardwoods not less than 0.7 N/mm².
  • Longitudinal joints must always be connected by finger joints, whereby the longitudinal pressure must be at least 12 N/mm².
  • In order to compensate for tension and humidity, the scantlings must be stored in a tempered room for at least two days before further processing or transport.
  • A non-erasable marking of the manufacturer in the adhesive joint is used as identification marking.
  • The product certification is marked as a quality feature on the outside of each manufactured scantlings.

Verein ึsterreichischer Bau- und Fensterkantelerzeuger

Schwarzenbergplatz 4 • A-1037 Wien
Tel: +43 (1) 712 26 01 • Fax: +43 (1) 713 03 09
office@austrokantel.at   © 2022
Imprint / Privacy